travis_farmer's latest activity
-
travis_farmer replied to the thread What my Autism is to me.the job prospects are not panning out, as i keep getting shot down at every turn. it is looking like my plan of making my way with my...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.if i run cables from the logic box to the control pendant console from the 7i72, i can power the LED button lights to show active...
-
travis_farmer replied to the thread My Shop Notes.the strapping can be secured to the pipe frame with either angle steel bracing, and sheet-metal screws, or suspended with metal...
-
travis_farmer replied to the thread My Shop Notes.thinking about a warm closet in my shop. an insulated closet that i can put the alarm and network electronics into, and place a...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.so, if i have battery backup for the CNC computer... what about the machine? may be a good use for my Off-Grid experiments. i could...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.just happened to think as i posted just now... the laser air will want to come on when the CNC is running, just to keep the dust from...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.been thinking about the dust shoe... and i wonder if the shoe and lift would be too much for the Z axis to lift up. the spindle alone is...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.at some point i will need to experiment with a dust shoe system. something that will not get in the way of the tool changer. i need some...
-
travis_farmer replied to the thread My Shop Notes.in my bedroom i have a 2 foot X 8 foot counter i would like out in my shop as a work bench/desk. i can make it rugged, but also so a...
-
travis_farmer replied to the thread My Shop Notes.for minimal insulation, i can use that thermal bubble-wrap https://www.amazon.com/dp/B07G64N67F/ for radiant heat thermal barriers. at...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.a relay pin can be referenced by it's id, "RLY025-34", on the wire sheet start and end. i want to label connectors somehow, too. so the...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.I have decided the master book will be a spreadsheet. i want at least the following fields: Wire Sheet ID = non-retiring numeric ID...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.the "roof" on top will be removable, as it will serve as the top raceway. the top raceway will route wires from logic to relays, and...
-
travis_farmer replied to the thread What my Autism is to me.https://youtube.com/playlist?list=PLqjygWFFGMJY425IVGbfEfSwuEd0pB-7T&si=e1nlQHY1ZTEb5apC A YouTube Public Playlist of high-energy...
-
travis_farmer replied to the thread My 48" X 48" CNC Router Table.it may be a good idea to layer the controls in a structured way. Power and stepper drivers, Master Logic, Analog, Input, Output and...
