• Registration is now limited to people that can answer the question(s) given. If all else fails, just ask me for the answer. ;-) If you already have an account, you can still login normally.

travis_farmer's latest activity

  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    ordered a pair of these: https://www.digikey.com/en/products/detail/tamura/L01Z200S05/529408 200A AC/DC Hall-Effect current sensors. one...
  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    sorta resigned myself to using the DC ATX PSU for the Rpi CM4 HA install, and the Arduino MQTT install. the RS485 to Ethernet device...
  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    i really should figure out how much current each of the LED light fixtures i have, takes to light up. makes a difference on how many i...
  • travis_farmer
    i am kinda thinking the smaller enclosure may not be big enough to fit everything. may be just as easy to continue with the big...
  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    not going to use my DC ATX PSU here, will use it elsewhere. it would be better to power each device (HA install, WiFi router, Konnected...
  • travis_farmer
    current line of thought: abandon the ISA back-plane idea, but use the DC ATX PSU for power. use a plain SPST switch to turn on the PSU...
  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    i think i can control the dump load with a Atmega328, and a large solid-state relay (with the load resistor i have already). i think the...
  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    Batteries planning on 4 deep-cycle Group 29DC from Wal-Mart. they will be bought as i can afford, so i will label each with the date...
  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    Solar/Wind power thoughts for a stop switch, i can use a 60A-ish non-fused disconnect switch, 2 pole. just connect 2 phases to one side...
  • travis_farmer
    yeah, 5V and 3.3V should be plenty of power, and i can use the 12V power adapter, so i will also have 12V to use, for whatever. i...
  • travis_farmer
    I hope to get a Nucleo-144 main-board from Ash, as it would greatly improve my build. i could have the main-board down on the bottom, or...
  • travis_farmer
    planning on changing my production build from a Giga, that i can afford one of, to a STM32 Nucleo-F439ZI, that i can afford more of down...
  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    i had thought of doing the kitchen where it was, but i am now thinking of having it right over the furnace. just a cook-top, and sink...
  • travis_farmer
    travis_farmer replied to the thread My 5th-Wheel camper.
    it would be a simple task to use my M4-ATX PSU in my camper for the HA install... just a thought... the router could be powered by it as...
  • travis_farmer
    i have thrown ideas back and forth, and even tried to sell the currently gutted out camper... but i think i will keep it and somehow...
    • camper_header.png
Top